Radon mitigation cost: what official sources say (and why quotes vary)

Published [object Object] · Updated 2026-11-18 · Sources checked 2026-11-18

The short answer

Published ranges differ by source and year. EPA's guide: $800–$2,500 (average about $1,200), figures from 2003. Pennsylvania DEP (2025): about $800–$1,200 in PA. Minnesota Department of Health: $1,500–$3,000. Get written quotes from one or more certified mitigators. Your home's foundation and layout matter most.

Published cost ranges

Source Range Notes
U.S. EPA, Consumer's Guide to Radon Reduction (revised Feb. 2003) $800–$2,500, average about $1,200 National figure. Over 20 years old (EPA 2003)
Pennsylvania DEP, Radon Resource Guide flyer (2025) about $800–$1,200 For Pennsylvania (PA DEP)
Minnesota Department of Health $1,500–$3,000 "in general" Undated web page, retrieved 2026-11-18 (MDH)
National Radon Program Services (Kansas State Univ.) about $1,200 average, $800–$2,500 range Repeats EPA's figures (NRPS)

EPA's newer 2016 edition of the guide leaves out dollar figures. It says most homes "can be fixed for about the same cost as other common home repairs" and recommends getting an estimate from one or more qualified contractors (EPA).

Costs by type of system (EPA, 2003)

EPA's 2003 guide listed typical contractor installation ranges by technique (EPA 2003):

Technique Typical radon reduction Installation (2003) Annual operating cost (2003)
Sub-slab suction (depressurization) 50–99% $800–$2,500 $50–$200
Passive sub-slab suction 30–70% $550–$2,250 some energy penalty
Drain-tile suction 50–99% $800–$1,700 $50–$200
Block-wall suction 50–99% $1,500–$3,000 $100–$400
Sump-hole suction 50–99% $800–$2,500 $50–$250
Sub-membrane depressurization (crawlspace) 50–99% $1,000–$2,500 $50–$250

What changes the price

EPA and MDH both point to the same main factors:

Running and upkeep costs

Getting a fair quote

  1. Use a certified mitigator. In Pennsylvania, mitigation must be done by someone DEP-certified (PA DEP).
  2. Get more than one written estimate if you can, as EPA suggests.
  3. Ask what's included: post-mitigation test, fan warranty, a manometer or alarm, and the pipe route.
  4. Retest after installation to confirm the level is below 4 pCi/L (CDC).

Find certified mitigators: Pennsylvania county pages.

Frequently asked questions

How much does radon mitigation cost?

It depends on the home and the source you check. EPA's Consumer's Guide (2003 revision) gives $800–$2,500 with an average of about $1,200; Pennsylvania DEP's 2025 resource flyer gives about $800–$1,200 in Pennsylvania; the Minnesota Department of Health says costs can generally range from $1,500 to $3,000. Get quotes from certified mitigators.

What does a radon system cost to run?

EPA's Consumer's Guide estimated typical annual operating costs (fan electricity plus heated or cooled air loss) of about $50–$200 for sub-slab suction systems. The National Radon Program Services compares the fan to a 60–90 watt light bulb running continuously.

How long does a radon fan last?

According to National Radon Program Services (Kansas State University), fan warranties are typically 5 years, with life spans of 10–15 years.

How much can mitigation lower radon?

EPA says some radon reduction systems can reduce radon levels by up to 99 percent.

Sources

  1. Consumer's Guide to Radon Reduction (EPA 402-K-03-002, revised February 2003), U.S. EPA (2003).
  2. Consumer's Guide to Radon Reduction (2016 edition), U.S. EPA (2016).
  3. How much can a radon mitigation system cost?, U.S. EPA.
  4. Radon Resource Guide flyer, Pennsylvania DEP (2025).
  5. Radon Mitigation Systems, Minnesota Department of Health.
  6. Radon Certification, Pennsylvania DEP.
  7. Radon and Your Health, CDC (June 18, 2026).
  8. Installing Mitigation, National Radon Program Services, Kansas State University.

This guide is for general information only. It is not medical, legal, or engineering advice. Read our disclaimer.